Skip to content
Hakel HSA-275/1+1 M S – Surge Arrester – Type 2+3 (Class II+III), 1+1 (2 Pole)Click to zoom

HSA-275/1+1 M S

Surge Arrester – Type 2+3 (Class II+III), 1+1 (2 Pole)

Brand:
Hakel
Model:
HSA-275/1+1 M S
Series / group:
G-Line

HSA-275/1+1 M S (Surge Arrester) : TYPE 2+3, CLASS II+III , 2 Pole

Key specifications

Class
Type 2+3 (Class II+III)
Uc
275 V AC / 350 V DC
Imax (8/20)
50 kA
Up
< 1,25 kV
Download Datasheet

Prefer to talk? Call 02 194 0672

Overview

(Hakel Surge Arrester) of the „G-Line“ range is a surge arrester according to EN 61643-11:2012 (IEC 61643-11:2011) consisting of high energy varistors. Its parameters enable its use in complex circumstances. The device is to be installed on the interface of LPZ 1 – LPZ 2 and higher zones according to standard EN 62305:2011 (IEC 62305:2010), i.e. into subsidiary switchboards and control boxes.

Technical Specifications

Technical Data

Test class according to EN 61643-11:2012 (IEC 61643-11)TYPE 2+3, CLASS II+III
Network typeTN-S, TT
Maximum continuous operating voltageUc275 V AC / 350 V DC
Maximum discharge currentImax50 kA
Nominal discharge current for class II test (8/20)In20 kA
Open circuit voltageUoc6 kV
Total discharge current (8/20 µs) L+N->PEI total50 kA
Voltage protection levelU p< 1,25 kV
Voltage protection level at U OCUp< 850 V
Impulse discharge current for class I test (10/350) N/PEIimp20 kA
Temporary overvoltage (TOV) L/NU T337 V/5 s
Temporary overvoltage (TOV) N/PEU T1200 V/0,2 s
Response time L/NtA< 25 ns
Response time N/PEtA< 100 ns
Max. back-up fuse160 A gL/gG
Short-circuit withstand capability 160 A gL/gGISCCR60 kA rms
Housing materialPolyamid PA6, UL94 V-0
Degree of protection of enclosureIP20
Operating temperatureϑ-40 °C ... +70 °C
Cross-section of the connected conductors (at tightening moment of clamps 3 Nm)25 mm 2 (solid)
Method of assemblyDIN rail 35 mm / any
Failure signalisation (S)optical function signalization target clear – ok / optical function signalization target red - fault
Potential free signal contact (S) (recommended cross-section of remote monitoring max.1 mm 2 )AC: 250 V / 1,5 A, DC: 250 V / 0,1 A
Lifetimemin. 100 000 h
Weightm179 g
Article number27 091

Dimensions & Technical Drawings

HSA-275/1+1 M S – Dimension drawing
Dimension drawing
HSA-275/1+1 M S – Internal wiring diagram
Internal wiring diagram
HSA-275/1+1 M S – Installation diagram
Installation diagram

Downloads & Resources

Need pricing or a technical recommendation?

Send us your quantities and requirements — our team will reply with a quotation.

Content verification notes (prototype)

These notes were generated during content migration and are for the AZGA team only.

  • Source value for "LPZ" is corrupted on existing site ("January 3, 2019") – verify (likely LPZ 1–3).

Original page: https://www.azgaelectric.com/surge-protection-devices/hsa-275-11-m-s/