Skip to content
Electrical Control Panels

How to Select the Right Thermostat for an Electrical Enclosure

NO contacts switch fans on, NC contacts switch heaters on. A short guide to contact types, setting ranges and ratings for enclosure thermostats.

By AZGA ELECTRIC5 min read

Alfa Electric THRV22 enclosure thermostat
On this page
  1. Why control enclosure temperature?
  2. NO vs NC contacts
  3. What else to check

Why control enclosure temperature?

Drives, power supplies and PLCs generate heat, and many electronic components are rated for a maximum ambient temperature inside the panel. In humid climates, condensation during cool nights is just as harmful. A small enclosure thermostat switches a filter fan or heater automatically to keep conditions within limits.

NO vs NC contacts

ContactBehaviourControlsExamples
NO (normally open)Closes when temperature rises above set pointFans, filter fans, coolersPlastim PTVT, Alfa THV2
NC (normally closed)Opens when temperature rises above set pointHeatersPlastim PTHT, Alfa THR2
NO + NCTwo independent set pointsFan and heaterAlfa THRV22

What else to check

  • Setting range – e.g. 0–60 °C on the models above.
  • Contact rating – Plastim PTHT/PTVT list 10 (2) A at 250/120 V AC; use an interposing relay or contactor for larger loads.
  • Mounting – clip-on for 35 mm DIN rail.
  • Position – mount away from direct heat sources and airflow paths so the sensor reads representative air temperature.

Frequently asked questions

Can one thermostat control both a fan and a heater?

Yes, a dual thermostat with one NO and one NC contact (such as THRV22) can control both with separate set points.

Sample article for the prototype — content to be reviewed by the AZGA technical team before publishing.

Need help applying this to your project?